Make a Lube Injector

Having a tool to get lube up your ass for fisting or toy play is, in my humble opinion, essential for safe and pleasurable play. Good lubrication reduces friction between skin and toy surfaces with the sensitive tissues in you lower gastrointestinal (GI) tract . Lubrication also captures bacteria and may even help reduce the chances of STI infection.

Getting lube in your hole is not too hard. Depending on what kind of lube you’re using you can easy squirt or push it in. But, what if you’re a depth-player. I love depth play and depending on the size of a man’s arm I can usually fit him in from anywhere pre-elbow to mid-bicep. So for me getting lube past my second hole is absolutely necessary.

Pushing and squirting lube in me just won’t to the trick. I looked for lube injectors in sex shops but found all of them woefully inadequate. Since I like creating things, do-it-yourself inventions, I decided to make my own. I went through several variations until I came up with a design that is sturdy, effective and relatively safe (depending on how you use it of course). The simple designed worked really well for me and continues to do so after many years.

My design was simple and very basic. All I did was to find a commercially available BBQ juice injector and make a couple of minor modifications. I have two versions that I use; one for getting Crisco a few inches inside my hole near the middle of my rectum. I use the other for depositing J-lube past my second hole. It’s important to note here that you want to use small quantities of lube because if you use too much, a hydraulic effect occurs and creates uncomfortable pressure as you try to move an arm or a toy up your GI tract.

My Crisco lube injector

To make the first injector, all I simply had to do was find a juice injector with a silicone o-ring plunger and throw away the injection needle. You want a silicone plunger because it will not degrade like rubber or plastic will. Rubber quickly becomes “gummy” and unusable. Some plastics will too, but plastic plungers are not recommended because they simple don’t fit tightly enough within the cylinder.

You can find scores of different brands online and on Amazon. I haven’t used this particular brand before, but this one looks ideal and only costs about $7.00

The second injector I made for depth to deposit my J-lube, was one I found at Home Depot. I later found the same model on Amazon for a lower price. With this one, all I did was to take one of the injection needles and cut it in half and then take a 1/4″ tube approximately 6″ to 8″ long and force it over the remaining part of the needle. It’s important that the fit is tight. I took a cigarette lighter to slightly melt the edges at the other end of the tubing to eliminate any sharp edges.

My deep J-lube injector

The tubing adds the necessary length to get the lube deep and also make it easy to siphon lube out of a bottle or other container

If you don’t use J-lube, due to the small diameter of the tube, you should be aware that thick lubricants won’t work. They will be nearly impossible to draw up into the cylinder. Lubes with a liquid consistency will work best.